Red SLM diode HL6363 MG 30-40mW 640nM

Sell or buy stuff.
Forum rules
Finding new homes for holography-related items is encouraged. Even commercial enterprises with goods to offer are welcome as long as it is in the spirit of members helping members. If a for-sale post reads like an infomercial, though, you have probably crossed the line of acceptability.
holomaker
Posts: 772
Joined: Wed Jan 07, 2015 8:01 am

Re: Red SLM diode HL6363 MG 30-40mW 640nM

Post by holomaker »

Ok if any one wants a complete red system, do the purchase on eBay (listed as head only),and I’ll include an extra red module or driver for said laser, if you do make a purchase, send me a note to include which extra u want. Thanks DB
holomaker
Posts: 772
Joined: Wed Jan 07, 2015 8:01 am

Re: Red SLM diode HL6363 MG 30-40mW 640nM

Post by holomaker »

Ok any feedback on these units ? I noticed there’s a projected pinhole approximately 10” ahead of the lasers output, by placing your optics @ that distance will provide a nice clean output ..
Valery
Posts: 275
Joined: Fri Jan 09, 2015 12:42 pm
Location: Yaroslavl , Russia

Re: Red SLM diode HL6363 MG 30-40mW 640nM

Post by Valery »

The parcel has arrived. Everything is safe and sound.
Next week I plan to test, I inform about the results. Now I'm doing an emulsion at 640 nm. for this laser.
142laser
Posts: 453
Joined: Wed Jan 07, 2015 10:14 am
Location: Tampa, FL

Re: Red SLM diode HL6363 MG 30-40mW 640nM

Post by 142laser »

The newest Data sheet online from Ushio says "Single Transverse Mode", the Single Longitudinal Mode was simply a mistake. However they may be fine for Holography and I will test a couple soon on a 2GHz FSR scanning interferometer to see what the real linewidth is, Remember HeNe;'s ate around 1.5 GHz so anything under that is fine and these may have a longer coherence length than HeNe. However they are almost certainly NOT single frequency...not "SLM"
Post Reply