Eye of the tiger

[Danny Bee]

this is shot with 457nm 45sec exposer
dcg mix 1/13/100
film 2 days old (normaly 1 day it would play in yellow)

water rince 1 min temp cold
(blot with paper towl)
iso 35% 80 degrees 15 sec
iso 70% 80 degrees 15 sec
iso 91% 80 degrees 15 sec

hot air dry both sides 2 mins
micro wave 1 min on high (this eliminate streaks and evens out the color)
then seal hologram

[Hans]

Great work Danny! Very impressive.

[Joe Farina]

Absolutely superb, Danny. An inspiration.

[dave battin]

nice work mr.B! will you be making an H2 from this hologram?

[Danny Bee]

dave hummmmmmm.... i could the play back in 532nm is bright its bandwith is about 532-480

[Danny Bee]

dave sound good i might try that bandwith is about 480-532

[Joe Farina]

Danny, a few questions if I may. Did you use Knox gelatin without any extra hardening? Also, why the paper towel blotting?And finally, do you find the microwave step equally helpful when using 100% iso, or is it more useful when using the 91% for the final bath? Thanks, Joe.

[Danny Bee]

Danny, a few questions if I may. Did you use Knox gelatin without any extra hardening? Also, why the paper towel blotting?And finally, do you find the microwave step equally helpful when using 100% iso, or is it more useful when using the 91% for the final bath? Thanks, Joe.

hi joe ....yes plain Knox gelatin without any extra hardening
I blot it because i have a few feet from bath room where i have running water ..to the craft room where i have iso bath control.
"microwave step equally helpful when using 100% iso" dont know... im using 91% right now and it helps big time

[Hans]

Did you use Rapid fixer for development or just the water rinse?

[Danny Bee]

Did you use Rapid fixer for development or just the water rinse?

just water....