Holographyforum.org / holowiki.org

this is my test of Geola plymer using fiber lens to even out the color mix

i chose this object because it made a good hologram in silver fuji, and its much brighter done in the polymer

Nice work, can you detail a bit the recording conditions?
Thx

yes, the mix of the R+G beams are more of a greenish yellow .. because it has a higher red sensitivity. the beams was spread with a fiber negative lens with the curved side toward the beams and the flat side toward the plate angle of the beam was about 30% to the plate. expose was about 5 mins. you can see visually the change in the polymer as you expose it. then set out in the sun to bleach out the dyes

Nice, thank you

nice thank you very much