Holographyforum.org / holowiki.org

Posted: **Fri May 25, 2018 5:33 am**

Finally done

: S__26419227.jpg (1.14 MiB) Viewed 11550 times

https://youtu.be/_PnP9Djp7dA

: S__26419228.jpg (926.96 KiB) Viewed 11550 times

https://youtu.be/AKsnOW2Bh7c

: S__26419229.jpg (745.63 KiB) Viewed 11550 times

https://youtu.be/Ruwqx3yNf90

and

https://youtu.be/0sgQQLgujas

Posted: **Fri May 25, 2018 1:15 pm**

Nice work, what were your final steps for sealing the hologram?

Posted: **Fri May 25, 2018 11:34 pm**

I use clear epoxy for sealing my hologram.

I use this one 3$. It has extra working time 20min but not very clear and have super small bubbles in it and little yellow.

: 1pack can seal 2 and a half 7x9 plate; A4A76108-8287-4936-A847-F2A232378537.jpeg (186.74 KiB) Viewed 11541 times

Holographyforum.org / holowiki.org

Improvement on my project

Re: Improvement on my project

Re: Improvement on my project

Re: Improvement on my project