Page 3 of 3
Re: Improvement on my project
Posted: Fri May 25, 2018 5:33 am
by Zeta
Finally done
- S__26419227.jpg (1.14 MiB) Viewed 12388 times
https://youtu.be/_PnP9Djp7dA
- S__26419228.jpg (926.96 KiB) Viewed 12388 times
https://youtu.be/AKsnOW2Bh7c
- S__26419229.jpg (745.63 KiB) Viewed 12388 times
https://youtu.be/Ruwqx3yNf90
and
https://youtu.be/0sgQQLgujas
Re: Improvement on my project
Posted: Fri May 25, 2018 1:15 pm
by pluto
Nice work, what were your final steps for sealing the hologram?
Re: Improvement on my project
Posted: Fri May 25, 2018 11:34 pm
by Zeta
I use clear epoxy for sealing my hologram.
I use this one 3$. It has extra working time 20min but not very clear and have super small bubbles in it and little yellow.
- 1pack can seal 2 and a half 7x9 plate
- A4A76108-8287-4936-A847-F2A232378537.jpeg (186.74 KiB) Viewed 12379 times