oooh..bum...i may have to rework my table..

These are all of the old posts from the first two years of the forum. They are locked.
Updated: 2005-03-28 by HoloM (the god)
Locked
danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

on exposer over 3 mins i get movement....maybe i need 2 intertubes on each leg of the table.....hooo hummm.....im at witz end , this table is going to give me gray hairs before my time
danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

this was a copy...but found I still need to rework my table...too much noise for long exposers
danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

JohnFP

oooh..bum...i may have to rework my table..

Post by JohnFP »

Another DCG caterpillar emerges as a butterfly.

Good job!!!
danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

i gave it a 5th leg in the middle off centered a bit, and 2 intertubes on each leg
Michael Harrison

oooh..bum...i may have to rework my table..

Post by Michael Harrison »

What's an interferometer test show you?


danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

have to clean up my mess first.. got abot 1 hour more of clean up

danny bruza

oooh..bum...i may have to rework my table..

Post by danny bruza »

it come back very fast when i tap my foot on the floor.....and table.....have to try it when a car goes down the street
Locked