Pictures of my setup

[HoloM]

IMG_6419.JPG (1.07 MiB) Viewed 3824 times

IMG_6418.JPG (891.8 KiB) Viewed 3824 times

IMG_6420.JPG (1.2 MiB) Viewed 3823 times

A few pictures of my setup

[HoloM]

IMG_6428.JPG (1.2 MiB) Viewed 3822 times

IMG_6424.JPG (981.2 KiB) Viewed 3822 times

IMG_6423.JPG (968.57 KiB) Viewed 3822 times

[HoloM]

IMG_6431.JPG (1.37 MiB) Viewed 3822 times

IMG_6430.JPG (1.44 MiB) Viewed 3822 times

IMG_6427.JPG (1.14 MiB) Viewed 3822 times

[BobH]

Very nice. I like the legs for your table. And those extrusions look like they work well for holding plates.

[Grayham]

Love the plate holders.
That's an idea I may borrow

Grayham

[Gilmer]

That's a real nice setup you have there.

[jrburns47]

Can you share source for plate holder extrusions? They look similar, but slightly different from, the Thorlabs XE25 construction rails.

[admin_jsfisher]

They look to be T-slot aluminum extrusions. There are many sources for them. Possible sources include 3D printer kit suppliers.

[jrburns47]

Right - did google & ebay searches for them and found many variations on the theme. None exactly like these though. Thorlabs looks like the most apt for holography and only slightly more expensive than others with the added benefit of anodized black and apparent end rectilinear precision. 80/20 has black but the sides are not flat.

[thycore]

IMG_6423.JPG

On this photo we can see a microscope objective off-ray any use in this setup ? Also what is this glass-mirror-whatever box in the beam on the right ?

Thanks for sharing, this should become a good habit every body share his/her setup xD