Compass 315M

[barcar]

I have recently purchased a Compass 315M 532-150.

I do not have the cable that connects the analog controller to the laser head.

I am trying to make one up. I have a SUB-D 25 pin female connector with numbered leads (1 to 25) which I ordered on eBay.

Can anyone tell me, do the 25 pins on the laser head go 1 to 25 left to right to match up with the 1 to 25 leads coming from the controller?

I also have a heat sink, a power supply, and a quick start adapter. So the cable is the last thing I need.

Thanks.

[jrburns47]

https://www.repairfaq.org/sam/laserscl.htm#sclcpsmd
You’ll find what you need in the above link. You’ll have to go through the very extensive TOC to get to the solid state (ss) laser section but it’s worth it.
Here’s a screenshot of one page describing the 25 pins. There’s much more info there if you’re willing to go through the info about the 315-M.
If this doesn’t work for you, post here again and I’ll put you I touch with Sam G.
Good luck.

[barcar]

Thanks for the help. That's what I was looking for.

[holomaker]

Got one here , $40 and it’s yours ! Send me a PM if you want it …..

[holomaker]

What country do you live in ?

[barcar]

I'm in Canada. Please check your PMs, where I've left my email. Let's use that to communicate further as I've had some connection issues accessing the forum recently.

[holomaker]

I checked and was no address! I’ve now sent you a PM , please ck for my email address

[barcar]

Thank you. I've sent you an email and another PM with my address in it.