Bayfol
Posted: Mon Jul 19, 2021 11:31 am
I've been doing some test with this polymer to find something to work as and adhesive , and came across one thing that works, 3d uv resin
the hologram is shot at 532nm for test, this test polymer was coated on both sides with uv resin the layer hast to be thin and cured in sun light or uv quickly after lamentation,
If you delay and let the uv resin time to soak in the polymer it will swell up the fringes and shift to red.
the way I did it is use a piece scotch tape to tape the top of the hologram to the glass,
then bend it back, and put a bead of uv resin along the edge of the tape glass and polymer then squeegee it, then take a put it out into the sun.
then when its cured you can remove the coversheet and then ether uv glass to the top or paint thin coat on top and cure in sun light
trying some other thing but will post them later
the hologram is shot at 532nm for test, this test polymer was coated on both sides with uv resin the layer hast to be thin and cured in sun light or uv quickly after lamentation,
If you delay and let the uv resin time to soak in the polymer it will swell up the fringes and shift to red.
the way I did it is use a piece scotch tape to tape the top of the hologram to the glass,
then bend it back, and put a bead of uv resin along the edge of the tape glass and polymer then squeegee it, then take a put it out into the sun.
then when its cured you can remove the coversheet and then ether uv glass to the top or paint thin coat on top and cure in sun light
trying some other thing but will post them later