If I am changing from a diode laser to more powerful pulse laser, what changes should I expect to have to make? They are both Green lasers, but the pulse laser will be significantly more powerful. How do I make sure I get the proper exposure? Is there anything I need to compensate for since it is now a pulse?
Any help is appreciated. If you need more info let me know and I will do my best.
lasers
lasers
If it is a mode locked or rapidly Q-switched laser then this is not suitable for doing holography, IMHO.bryuly wrote:What do you mean by saw? I can look at it and it looks continuous; however, I was told it pulses very rapidly. Is this different than a pulse laser that is normally talked about? Can I just treat the laser as a continuous one and take time average holograms still?
lasers
The Coherent Verdi series are CW (continuous wave) lasers.
http://www.coherent.com/lasers/index.cf ... 73&loc=834
I think the confusion may have arisen because these lasers are often used to pump Ti : Sapphire lasers
in femtosecond pulsed applications. But the Verdi itself does not pulse.
http://www.coherent.com/lasers/index.cf ... 73&loc=834
I think the confusion may have arisen because these lasers are often used to pump Ti : Sapphire lasers
in femtosecond pulsed applications. But the Verdi itself does not pulse.
lasers
A Verdi laser is great for holography. I would simply love to play with one of them. And Tom is correct it is a CW laser.
So back to your original question. The best answer I can give is get a light meter. Here is a very good one that can handle the power and is inexpensive so to speak. I have this one and it works great.
http://www.tftelectronics.co.uk/TFT%20L ... 0Meter.htm
While you wont be able to use the meter in the unexpanded raw beam, once your beams go though the spatial filter, you will be able to read power. Then just follow the guidelines for the film you are using for total energy and adjust your ratios as needed for the type of hologram you are making.
So back to your original question. The best answer I can give is get a light meter. Here is a very good one that can handle the power and is inexpensive so to speak. I have this one and it works great.
http://www.tftelectronics.co.uk/TFT%20L ... 0Meter.htm
While you wont be able to use the meter in the unexpanded raw beam, once your beams go though the spatial filter, you will be able to read power. Then just follow the guidelines for the film you are using for total energy and adjust your ratios as needed for the type of hologram you are making.